Omni Power 2.5 Bar MAP Sensor Water/Methanol Injectors/Nozzles

Omni Power 2.5 Bar MAP Sensor Water/Methanol Injectors/NozzlesOmni Power USA 3, 4 & 5 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip. Pressure changes are calculated on a true linear 0 5 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows the Omni Power USA 4 Bar MAP sensor to remain a minimum

Legs and mounting plates are made from robust 3/8-inch steel plate

albeit raised up 26mm (1")

all other models may require additional modification to the inlet hose or surrounding components (including breather hoses/fittings) for installation

Install a CANchecked display and monitor what's going on

Lever Clips for Precaution

Included with everything you need to install

When a second pump is added to the system the flow is greatly increased and the factory fuel pressure regulator is unable to control fuel pressure

metals expand and ultimately components fail

Hard anodized finish to ensure against corrosion

digital and frequency inputs into an AEMnet CAN bus signal that can be transmitted to the CD-5 Carbon and CD-7 Digital Dashes

Excellent ride quality

Additional wiring for a 0-5v or RS232 Serial output can be added by the user for outputting to a data logger